X hits on this document

403 views

0 shares

0 downloads

0 comments

170 / 182

REASSEMBLY - FRONT SECTION

5. Reinstall the auxiliary drive gear assembly on rear of mainshaft. Use a flanged-end driver and maul to seat bearing in case bore.

  • 7.

    Install the snap ring in groove at end of main- shaft.

    • K.

      Installation of Drive Gear Nut and Front Bearing Cover

6.

Align the six capscrew holes in retainer with the tapped holes in case and install capscrews. Tighten to recommended torque ratings and lock- wire the capscrews in groups of three.

1. Apply Loctite grade 277 sealant to cleaned threads of new drive gear bearing nut. DO NOT REUSE OLD NUT. NOTE: For models equipped with a snap ring to retain bearing, install the snap ring in groove of input shaft and proceed to No. 4.

Document info
Document views403
Page views403
Page last viewedMon Dec 05 03:43:55 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments