X hits on this document

352 views

0 shares

0 downloads

0 comments

171 / 182

REASSEMBLY-FRONT SECTION

2. Engage two mainshaft sliding clutches into gear to prevent transmission from rotating.

4. If previously removed, install the oil seal in drive gear bearing cover of models so equipped.

3. Install the nut on shaft (left hand threads). Using a drive gear nut installer, tighten to 250-300 lbs/ft of torque. Use a punch and maul to peen the nut into the two milled slots of input shaft.

5. Install the drive gear bearing cover and gasket, making sure to align the oil return hole in case. Secure cover on case with retaining capscrews (inset).

Document info
Document views352
Page views352
Page last viewedSat Oct 29 00:12:17 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments