X hits on this document

479 views

0 shares

0 downloads

0 comments

173 / 182

INSTALLATION-COMPANION FLANGE, AUXILIARY SECTION AND CLUTCH HOUSING

B. Installation of Auxiliary Section

NOTE: Make sure the bearing inner race is in- stalled on front of each auxiliary countershaft BE- FORE proceeding with the following.

1. Attach a chain hoist to auxiliary. Move the as- sembly evenly into rear of front case, piloting it on the dowel pins. As assembly is moved forward, the countershaft drive gears will mesh with the auxiliary drive gear. IMPORTANT: On 8-speed "L" model auxiliary sections, shift the deep reduction sliding clutch into deep reduction before installing auxiliary. This will prevent possible timing error.

3. The auxiliary section can also be installed with transmission set in the vertical position. Block under the clutch housing to prevent damage to the input shaft, position the corresponding new gasket on plate/housing mounting surface and lower the assembly onto rear of front case. Install the retaining capscrews and tighten securely. See TORQUE RECOMMENDATIONS. IMPORTANT: On 8-speed "LL" model auxiliary sections, shift the deep reduction sliding clutch into deep reduction before installing auxiliary. This will prevent possible timing error.

2. Install the retaining capscrews in flange of aux- iliary pIate/housing and tighten to secure the aux- iliary section to the front section. See TORQUE RECOMMENDATIONS.

Document info
Document views479
Page views479
Page last viewedThu Dec 08 14:53:38 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments