X hits on this document

497 views

0 shares

0 downloads

0 comments

174 / 182

INSTALLATION - COMPANION FLANGE, AUXILIARY SECTION AND CLUTCH HOUSING

C. Installation of Universal Joint Companion Flange or Yoke

1. For models so equipped, install the speedometer drive gear or replacement spacer in position on hub of companion flange or yoke. Install the com- panion flange or yoke on splines of output shaft and move into rear bearing cover. NOTE: For 14608LL models, the speedometer drive gear or replacement spacer is installed on output shaft prior to installation of rear bearing cover.

2. Lock the transmission by engaging two main- shaft gears with sliding clutches. Install the washer and/or nut on output shaft and tighten nut using 450-500 lbs/ft of torque.

Document info
Document views497
Page views497
Page last viewedFri Dec 09 20:17:33 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments