X hits on this document

511 views

0 shares

0 downloads

0 comments

175 / 182

INSTALLATION - SHIFTING CONTROLS

SHIFT BAR HOUSING ASSEMBLY

A. Installation

1. Place all three mainshaft sliding clutches in the neutral position.

Install the new shift bar housing gasket in posi- tion on case.

2. With all three shift bars in the neutral position, in- stall the shift bar housing assembly on case, fit- ting the shift yokes into slots of corresponding sliding clutches. NOTE: Avoid tilting the assembly during installation as the three sets of tension springs and balls are free to be released from bores in top of housing.

3. Install the capscrews in housing and tighten to secure the assembly to case.

Document info
Document views511
Page views511
Page last viewedSat Dec 10 17:33:10 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments