X hits on this document

449 views

0 shares

0 downloads

0 comments

29 / 182

AIR SYSTEM

RANGE VALVE A-3546

NOTE: This valve provides range selection ONLY. When equipped on 15-Speed Models, the dash-mounted Deep Reduction Valve is required to provide deep reduction selections.

OUTLET (BLACK AIR LINE)

Cut 6155-1/84

3. Remove the seal, insert valve O-ring and spring from rear housing.

2. Install the air lines with their sheathing and O- rings on the gear shift lever.

4. If necessary, remove the two felt seals. Punch out the roll pin to remove the control knob from slide.

3. Secure the valve on gear shift lever with mounting clamp. The control knob should face to the front and be approximately 6“ below the centerline of ball grip.

4. Attach the air lines.

Removal and Disassembly

Reassembly and Installation

  • 1.

    Disconnect the air lines and loosen clamp s curing the valve to gear shift lever. Remove valve.

  • 2.

    Remove the four screws to separate the front and rear housings and remove the slide and two sets of position springs and balls.

e- 1 . Refer to the drawing for proper reassembly. Use a VERY SMALL amount of silicone lubricant on the O-rings to avoid clogging ports. A small amount of grease on the position springs and balls will help to hold them in place during reassembly.

Document info
Document views449
Page views449
Page last viewedWed Dec 07 09:16:39 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments