X hits on this document

503 views

0 shares

0 downloads

0 comments

54 / 182

DISASSEMBLY AND REASSEMBLY SHIFTING CONTROLS

B. Reassembly of Gear Shift Lever Housing Assembly

  • 3.

    Remove the tension spring, washer and gear shift lever from housing.

    • 1.

      With the gear shift lever housing secured in vise as during disassembly, install the spade pin in bore of housing tower. If previously removed, in- stall the O-ring in tower groove.

  • 4.

    Remove the spade pin from bore in housing tower. If necessary, remove the O-ring from groove inside tower.

    • 2.

      Position the gear shift lever in housing with spade pin in lever ball slot and install the tension spring washer over ball, dished-side up.

Document info
Document views503
Page views503
Page last viewedSat Dec 10 02:45:41 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments