X hits on this document

405 views

0 shares

0 downloads

0 comments

56 / 182

DISASSEMBLY AND REASSEMBLY SHIFTING CONTROLS

SHIFT BAR HOUSING ASSEMBLY

A. Removal and Disassembly NOTE: For models equipped with an Oil Pump and/or Cooler Assemblies, make sure to discon- nect the lube line at fitting on shift bar housing prior to proceeding with the following instruc- tions.

  • 1.

    Turn out the retaining capscrews, jar to break gasket seal and lift the shift bar housing from case. Remove gasket. NOTE: During disassembly, lay all parts on a clean bench in order of removal from housing to facilitate reassembly. Shift bars not being re- moved MUST be kept in the neutral position or in- terlock parts will lock bars. For disassembly and reassembly of "X" and "F" model assemblies, see Illustrated Parts List.

    • 2.

      Tilt the assembly and remove the three sets of tension springs and balls from bores in top of housing.

Document info
Document views405
Page views405
Page last viewedMon Dec 05 04:31:19 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments