X hits on this document

516 views

0 shares

0 downloads

0 comments

58 / 182

DISASSEMBLY AND REASSEMBLY SHIFTING CONTROLS

B. Reassembly of Shift Bar Housing Assembly

7. Move the short LO-Reverse speed shift bar to the rear of housing, removing the yoke from bar. As the shift bar is removed from housing, two %Ò in- terlock balls will drop from bottom bore of rear boss.

1. If previously removed, install the reverse-stop plunger in LO-Reverse shift yoke, making sure plunger is fully seated in bore at yoke slot.

8. If necessary, remove the plug, spring and reverse- stop plunger from bore in LO-Reverse speed shift yoke.

2. Install the spring in bore of yoke and onto shank of plunger.

Document info
Document views516
Page views516
Page last viewedSat Dec 10 22:29:46 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments