X hits on this document

522 views

0 shares

0 downloads

0 comments

59 / 182

DISASSEMBLY AND REASSEMBLY SHIFTING CONTROLS

3. Install the plug and tighten to compress spring (left). Back the plug out 1-1 1/2 turns and stake plug through the small hole in yoke (right).

5. Holding shank of plunger, install the actuating plunger in bore at top of center boss.

4.

With the shift bar housing secured in vise as during disassembly, hold notched-end of short LO-Reverse speed shift bar and install in lower bore of housing bosses, positioning the yoke on bar between the bosses. Install the yoke lock- screw, tighten and wire securely. NOTE: Start with the lower shift bore of rear boss and move to the left (front of housing). Keep bars in the neutral position during installation. DO NOT EXCEED the recommended torque ratings for yoke Iockscrews as over-tightening may dis- tort shift bars.

6. Install one 3/4" interlock ball in bore at top of rear boss. This ball rides between LO-Reverse and 1st- 2nd speed shift bars.

Document info
Document views522
Page views522
Page last viewedSun Dec 11 04:30:14 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments