X hits on this document

463 views

0 shares

0 downloads

0 comments

63 / 182

REMOVAL - COMPANION FLANGE, AUXILIARY SECTION AND CLUTCH HOUSING

B. Removal of Auxiliary Section

1. Turn out the retaining capscrews in auxiliary housing flange.

3. Remove puller screws and attach a chain hoist to auxiliary section. Move the assembly to the rear until free of front section and remove gasket.

2. Insert three puller screws in the tapped holes of housing flange. Tighten evenly to move auxiliary section to the rear and just far enough from front section to break gasket seal.

4. The auxiliary section can also be removed with transmission set in the vertical position. Block under the clutch housing to prevent damage to the input shaft, remove the retaining capscrews in housing flange and lift the assembly from front section. Remove gasket.

Document info
Document views463
Page views463
Page last viewedWed Dec 07 22:28:47 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments