X hits on this document

642 views

0 shares

0 downloads

0 comments

75 / 182

DISASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

G. Removal and Disassembly of

Output Shaft and Rear Bearing Assemblies NOTE: In addition to the above, refer to the illus- tration provided at Part D of this section.

2. If not previously done so, remove the snap ring and speedometer drive gear or replacement spa- cer from output shaft of models so equipped.

1. Turn out the capscrews and remove the rear bearing cover and gasket. If necessary, remove the oil seal from cover (inset).

Document info
Document views642
Page views642
Page last viewedSun Jan 22 00:28:16 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments