X hits on this document

432 views

0 shares

0 downloads

0 comments

76 / 182

DISASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

3. Temporarily reinstall rear bearing cover in posi- tion on housing ONLY to catch rear bearing cone released from bore in the following procedure.

5. Remove rear bearing cover and bearing cone.

    • 6.

      Remove the two bearing cups and outer spacer from bore in auxiliary housing.

  • 4.

    Use a soft bar and maul to drive the output shaft forward and through rear bearing assembly. This will cause the rear bearing cone to be released from bore in auxiliary housing. NOTE: When applying force to rear of output shaft, DO NOT AMAGE THREADS. Support front of shaft to avoid damaging the mainshaft quill once output shaft is free of bearing.

Document info
Document views432
Page views432
Page last viewedTue Dec 06 13:04:40 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments