X hits on this document

646 views

0 shares

0 downloads

0 comments

77 / 182

DISASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

7. Remove the bearing inner spacer from output shaft.

9. If necessary, remove the snap ring from I.D. of deep reduction gear of models so equipped.

8. Using the front face of deep reduction gear as a base, press the output shaft through the bearing and gear. This will free the bearing, gear, washer, and, for models so equipped, the spacer or oil re- tention ring. DO NOT DAMAGE MAINSHAFT QUILL.

Document info
Document views646
Page views646
Page last viewedSun Jan 22 04:04:01 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments