X hits on this document

685 views

0 shares

0 downloads

0 comments

79 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

B. Reassembly and Installation of Output Shaft and Rear Bearing Assemblies

    • 3.

      IMPORTANT: Mark any two adjacent teeth on deep reduction gear and repeat the procedure for the two adjacent teeth directly opposite the first set marked. A highly visible color of toolmakersÕ dye is recommended for making timing marks.

  • 1.

    Remount the output shaft in vise with threaded-end up and secure on range mainshaft. For models so equipped, install the stepped washer on shaft, large diameter step down.

  • 2.

    Install the splined spacer on output shaft. For models equipped with stepped washer on shaft, install the spacer with large diameter splines down (right).

    • 4.

      If previously removed, install the snap ring in deep reduction gear of models so equipped (in- set). Install the gear on output shaft, clutching teeth down and engaged with splines of spacer.

Document info
Document views685
Page views685
Page last viewedMon Jan 23 10:48:48 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments