X hits on this document

454 views

0 shares

0 downloads

0 comments

82 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS]

C. Reassembly and Installation of Deep Reduction Cylinder Assembly

16. If previously removed, install the oil seal in rear bearing cover (inset). Seal should be installed so the spring is to the front of cover.

1. If previously removed, install the small O-ring in bore of cylinder housing (inset). Position the cor- responding new gasket on housing mounting sur- face and install the deep reduction cylinder housing in rear bore of auxiliary housing, air channel to the right.

17. Position gasket on cover mounting surface and install the rear bearing cover on auxiliary hous- ing. Use the nylon collar and brass washer with capscrew at the chamfered hole which intersects speedometer bore (inset). Tighten capscrews to se- cure cover to housing. NOTE: Because the collar becomes distorted when compressed, DO NOT REUSE OLD NYLON COLLAR.

2. If previously removed, install the O-ring in groove of yoke bar piston.

Document info
Document views454
Page views454
Page last viewedWed Dec 07 13:26:01 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments