X hits on this document

555 views

0 shares

0 downloads

0 comments

83 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

    • 5.

      For models so equipped, install the insert valve in bottom exhaust port of cylinder cover as shown (left). Install the valve retaining nut in ex- haust port of cover and tighten to recommended torque ratings (right). NOTE: Prior to installation of insert valve, apply a small amount of silicone lubricant to O-rings on

      • O.

        D. of valve.

  • 3.

    Place the reduction yoke into position with slid- ing clutch, lockscrew hole to the front. From rear of auxiliary housing, insert the yoke bar through cylinder bore and into yoke, aligning the notch in bar with yoke lockscrew hole.

4. Install the yoke lockscrew, tighten and wire se- curely.

6. Position the corresponding new gasket on cover mounting surface and install the deep reduction cylinder cover, aligning the air channel with chan- nel in cylinder housing housing. Tighten capscrews to se- cure cover to cylinder housing.

Document info
Document views555
Page views555
Page last viewedTue Jan 17 13:09:01 UTC 2017
Pages182
Paragraphs2411
Words25289

Comments