X hits on this document

363 views

0 shares

0 downloads

0 comments

84 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

D. Installation of Low Range Gear

1. Install the coupler on range mainshaft, clutching teeth to the rear.

3. Install the splined tolerance washer on mainshaft and in hub of low range gear. Rotate the washer in groove of mainshaft to engage external splines with clutching teeth of gear and align square in- ternal spline with keyway of mainshaft. IMPORTANT: This washer is available in varying thicknesses. Use the splined tolerance washer that provides a snug fit in gear hub.

  • 2.

    Install the low range gear on mainshaft against coupler, clutching teeth to the front.

    • 4.

      Install the key in keyway of range mainshaft, in- serting the thick end of key in square internal spline of tolerance washer to lock low range gear on shaft.

Document info
Document views363
Page views363
Page last viewedSat Dec 03 09:59:15 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments