X hits on this document

508 views

0 shares

0 downloads

0 comments

87 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

4. Install the snap countershaft

ring .

in

groove

at

rear

of

each

1. If previously remvoed, install the O-ring in bore of range cylinder housing.

5. Position the corresponding new gasket on cover mounting surface and install both rear bearin covers. Tighten capscrews to secure covers to auxiliary housing. NOTE: For reassembly and installation of models equipped with an Auxiliary Oil Pump Assembl on rear of countershaft, see OPTIONS.

g

y

2. Position the corresponsding new gasket on hous- ing mounting surface and install the cylinder housing in rear bore of auxiliary housing, air fit- ting to the upper left. Tighten capscraews to se- cure cylinder housing to auxiliary housing.

Document info
Document views508
Page views508
Page last viewedSat Dec 10 10:46:00 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments