X hits on this document

468 views

0 shares

0 downloads

0 comments

88 / 182

REASSEMBLY - AUXILIARY SECTION (8-SPEED "LL" MODELS)

3. Place the range yoke into position with sliding clutch of synchronizer assembly, long hub of yoke to the rear. Insert threaded-end of yoke bar through yoke and into bore of range cylinder housing, aligning the notches in bar with yoke Iockscrew holes.

6. In cylinder housing bore, install the range piston on yoke bar, flat side to the rear. Secure with nut tightened to recommended torque ratings (inset).

  • 4.

    Install the two yoke Iockscrews, tighten and wire securely.

    • 7.

      Position the corresponding new gasket on cover mounting surface and install teh range cylinder cover on housing, open port to the upper left. Tighten capscrews to secure cover to housing.

  • 5.

    If previously removed, instll the O-rings in th

    • I.

      D. and O.D. of range piston.

e

Document info
Document views468
Page views468
Page last viewedThu Dec 08 03:03:27 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments