X hits on this document

406 views

0 shares

0 downloads

0 comments

96 / 182

DISASSEMBLY - AUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

D. Removal and Disassembly of Output Shaft and Rear Bearing Assemblies

1. Use a soft bar and maul to drive the output shaft forward and through rear bearing assembly.

3. Using the front face of low range gear as a base, press the output shaft through the gear and bearing. Remove the bearing and washer from hub of low range gear.

2. Remove the bearing inner spacer from output shaft.

4. If necessary, remove the snap ring from low range gear of models so equipped.

Document info
Document views406
Page views406
Page last viewedMon Dec 05 04:55:14 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments