X hits on this document

509 views

0 shares

0 downloads

0 comments

97 / 182

DISASSEMBLYÑAUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

5. Remove the splined spacer from output shaft.

7. Turn out the capscrews and remove the rear bearing cover and gasket. The rear bearing cone will drop from bore in auxiliary plate when cover is removed. If necessary, remove the oil seal from cover (inset).

6. Remove the stepped washer from shaft of models so equipped.

8. Remove the two bearing cups and outer spacer from bore in auxiliary plate.

Document info
Document views509
Page views509
Page last viewedSat Dec 10 11:18:49 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments