X hits on this document

495 views

0 shares

0 downloads

0 comments

99 / 182

REASSEMBLY - AUXILIARY SECTION (9-SPEED AND RT-8608L MODELS)

5. Install the washer on shaft; 11609, 12609 models flat side of washer facing up, 14609 models flat side of washer facing down.

7. Install the bearing inner spacer on output shaft.

6.

Heat the front bearing cone and install on shaft against washer, bearing taper up. NOTE: DO NOT HEAT- BEARING ABOVE 275oF (136oC). If possible, use heat lamps as source.

8. Install the front bearing cup in bore of auxiliary plate, taper to the inside. Use a soft bar to start cup into bore.

Document info
Document views495
Page views495
Page last viewedFri Dec 09 18:04:32 UTC 2016
Pages182
Paragraphs2411
Words25289

Comments