X hits on this document

PDF document

September 1999 P/N 880-503284-001-A1 - page 16 / 65

165 views

0 shares

0 downloads

0 comments

16 / 65

Quick Set-Up

Login

Press ENTER.

The prompt YOUR PASSWORD? is displayed.

Initially there is no password, press ENTER.

The NCC 2020 Main Menu is displayed:

NOTE: The prompt line and menu names will refer to the NCC 2020 as a TAC 2010. This is because an NCC 2020 is a TAC 2010 T1 CSU to which the Craft interface and node controller functions have been added.

Figure

SITE NODE

2-2 0 NCC 2020 Main Menu -- VERILINK NCC NODE NAME: ID:

CONTROLLER

at[1,1]:

FW

Rev

4.75

--

<- SLOT ->

SHELF 1 DL 2 3 4 KEY: C=CSU, D=DIU, F=DIU/DDS, B=DIU/DBU, R = SRD, I=IDCSU, T=TU, S=SMDS, V=VCU 1 [C] 2 D 3 4 6 8 9 10 11 12 13 5 7

  • S)

    shelf/slot

  • N)

    near element

  • F)

    far element

  • C)

    configuration

  • P)

    performance

[1,1] NEAR TAC 2010 >

  • D)

    diagnostics

  • O)

    node administration

  • M)

    monitor alarms (OFF)

  • A)

    alm to net mgr (OFF)

  • X)

    system log off

CSU Configuration

When installing an NCC 2020 or TAC 2010 module which is to be used with any type of DIU 21xx module, always configure the CSU module before configuring anything on the DIU 21xx module. When the DIU 21xx is configured, it is connected logically to a CSU. At that instant the DIU gets information from the CSU as to which data bus in the shelf midplane to use. If the CSU has not been configured yet, the DIU 21xx will not get a correct bus assignment. This is why the CSU should be configured first.

Type “C” and press ENTER. The Configuration Menu is presented.

2-2

Verilink NCC 2020 User Manual

Document info
Document views165
Page views165
Page last viewedThu Dec 08 15:21:49 UTC 2016
Pages65
Paragraphs3233
Words20026

Comments