X hits on this document

PDF document

September 1999 P/N 880-503284-001-A1 - page 2 / 65

120 views

0 shares

0 downloads

0 comments

2 / 65

ii

Copyright Notice

Trademarks

FCC Requirements

Copyright 1999 Verilink Corporation. All rights reserved.

This document does not create any express or implied warranty about Verilink or about its products or services. Verilink’s sole warranty is contained in its product warranty. The end-user documentation is shipped with Verilink’s products and constitutes the sole specifications referred to in the product warranty. Verilink has made reasonable efforts to verify that the information contained herein is accurate, but Verilink assumes no responsibility for its use or for any infringement of patents or other rights of third parties that may result. The customer is solely responsible for verifying the suitability of Verilink’s products for its use. Specifications are subject to change without notice.

Verilink is a registered trademark of Verilink Corporation. Access System 2000, WANscope, VeriStats, and FrameStart are trademarks of Verilink Corporation.

Any named products herein are trademarks of their respective companies.

This equipment has been tested and found to comply within the limits for a Class A digital device pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide protection against harmful interference in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the user manual, can cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception—which can be determined by turning the equipment off and on—try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with Part 68 of the FCC Rules. On the rear, side or bottom of the unit is a label that contains the FCC registration number and other information. If requested, provide this information to the telephone company.

 All direct connections to the network lines must be made using standard plugs and jacks (compliant with Part 68). The following tables list the applicable registration jack universal order codes (USOCs), facility interface codes (FICs), and service order codes (SOCs). These are required to order service from the telco.

Port ID

REN/SOC

FIC

USOC

1.544 Mbit/s SF 1.544 Mbit/s SF, B8ZS 1.544 Mbit/s ANSI ESF 1.544 Mbit/s ANSI ESF, B8ZS

6.0N

04DU9 -BN 04DU9 -DN 04DU9 -1KN 04DU9 -1SN

RJ-48C jack

For T1 interfaces:

For DDS interfaces:

REN/SOC

FIC

6.0N

04DU5 -56 04DU5 - 64

USOC

RJ-48S jack

56 kbit/s 64 kbit/s

Port ID



If the unit appears to be malfunctioning, inform the telco and disconnect it from the network lines until the source of trouble is determined to be your equipment or the telephone line . If your equipment needs repair, it should not be reconnected until it is repaired.

 The unit has been designed to prevent harm to the network. If the telephone company finds that the equipment is exceeding tolerable parameters, it can temporarily disconnect service. In this case, the telephone company will provide you advance notice if possible.

Verilink NCC 2020 User Manual

Document info
Document views120
Page views120
Page last viewedSat Dec 03 02:31:45 UTC 2016
Pages65
Paragraphs3233
Words20026

Comments