X hits on this document

PDF document

September 1999 P/N 880-503284-001-A1 - page 36 / 65

132 views

0 shares

0 downloads

0 comments

36 / 65

Configuration

Menu Option

Description

Instructions

Interval

I1)

Interval

I2)

Selects the delay between tries (attempts to connect to the network manager) for the primary (I1) and secondary (I2) paths to the management PC(s).

interval 0-59S or 1-59M or 1-24H >

Enter a numeric value in one of the ranges shown. Include the letter “S” for that many seconds; “M” for minutes or use “H” if you really want to wait for hours before learning about alarm conditions.

Example—“15S” for fifteen seconds.

Primary address......A1)

Primary address......A2)

Use this prompt to enter the digits used to establish a call for the primary path (A1) or the secondary path (A2) used to reach the network manager PC.

If your type selection is MODEM, this field would be the phone number for the modem to dial.

If your type selection is X.25 PAD, this is the string your particular PAD requires to establish a call to the AM2000 PC.

This field is left empty for permanent stat mux connections or direct connection.

X) Exit menu

Exits to menu above.

Returns to Node Administration Menu.

Firmware Upgrade Procedures

Firmware upgrades to an NCC 2020 may be done in two ways:

Replacing the socketed EEPROMS which hold the node management and CSU firmware.

Using either Access Manager 2000 or Node Manager to download new code to the module.

Replacing EEPROMs

The TAC 2010 CSU firmware in an NCC 2020 resides in the EEPROM in socket U11.

The NCC 2020 management firmware resides in the EEPROM in socket U22.

Verilink offers upgrade kits which include one each of these two integrated circuits. Contact Verilink Technical Support if you require a firmware upgrade.

Network Management Programs

Both Access Manager 2000 and Node Manager offer download procedures which may be used to upgrade either the CSU or network management portions of an NCC 2020.

For details on using Access Manager 2000 to upgrade an NCC 2020 or the other modules it controls, refer to the Access Manager 2000 User Manual.

3-14

Verilink NCC 2020 User Manual

Document info
Document views132
Page views132
Page last viewedSun Dec 04 10:21:04 UTC 2016
Pages65
Paragraphs3233
Words20026

Comments