X hits on this document

PDF document

September 1999 P/N 880-503284-001-A1 - page 9 / 65

162 views

0 shares

0 downloads

0 comments

9 / 65

Chapter

1

Scope

Installation Information

Related Verilink Documents

Management Options

Overview

This user manual describes the NCC 2020 Node Controller module, a component of Verilink’s Access System 2000 (AS2000) platform. The NCC 2020 is a network management module which also functions as a T1 CSU.

This manual assumes you are already familiar with the standard AS2000 products. Where appropriate, the text refers you to a specific Access System 2000 manual for greater detail.

For information on installing and replacing shelves, modules, and power supplies, see the manual AS2000, The Basics.

NOTE: Do not attempt to mix NCM, NCC, and SCC node controllers in the same node. There can be only one type of node controller in a node.

Refer to the following related AS2000 manuals:

  • The NCC 2130 User Manual documents the network controller version of the TAC 2130 Integrated T1 DSU/CSU (IDCSU). AS2000, The Basics provides general information about Verilink products.

Node Manager for Windows 95 User Manual, documents the Verilink network management program designed to operate under Windows™ 95 or Windows™ NT.

Access Manager 2000 User Manual, documents the Verilink network management program designed to operate under Windows™ 3.1 (only).

The NCC 2020 Node Controller and Channel service unit module allows users to configure directly through an ASCII terminal port (Craft interface) or by using either of two Verilink node management programs. This provides full control for configuration management, performance monitoring, and maintenance.

The NCC Node Controllers support the following:

ASCII Craft interface, local access by direct connection to the Craft port.

Verilink NCC 2020 User Manual

1-1

Document info
Document views162
Page views162
Page last viewedThu Dec 08 11:58:37 UTC 2016
Pages65
Paragraphs3233
Words20026

Comments