X hits on this document

227 views

0 shares

0 downloads

0 comments

16 / 30

Brass Sales Co Inc.

“M7RL” Series

“M7RL045AAW”

45,000 BTU

“M7RL060AAW”

60,000 BTU

“M7RL072AAW”

60,000 BTU

Part # M745 M760 M772

95+% Downflow GAS Furnace Short

Price

DIMENSIONS

Short Model (w/o Coil Box)

High Efficiency / Direct Vent Condensing Downflow Gas Furnace Induced Draft - 95%+ AFUE / Input 45,000 thru 72,000 Btuh

19 3/4” Wide 23 3/4” Deep 56” Tall

The high efficiency downflow gas furnace is especially designed for Modular Housing. It may be installed in a utility room, or enclosed in a closet. CSA design certified for use in the United States and Canada.

Tall Model (Pictured)

• Fixed 30 second blower delay: At burner start-up assures a warm outlet air temperature at furnace start-up. Adjustable blower off settings (60, 90, 120 and 180 seconds). • Fixed 30-second post purge: Increases life of heat exchanger. • Dependable, hot surface ignitor: Innovative application of silicon nitride type igniter. Utilizes proven Smartlite® technology. • Tubular primary heat exchanger: Heavy gauge aluminized steel heat ex- changer assures a long life. • Stainless steel secondary heat exchanger: Assures a long life. • 90 second fixed cooling cycle blower-off delay (TDR): Increases cooling performance when matched with a NORDYNE coil. • Sealed combustion approved for direct vent furnace, category IV venting system: May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation. • LP convertible: Simple burner orifice and gas valve regulator change for ease of convertibility. • Multi-speed direct drive blower: Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection. 40VA transformer included. • Diagnostic lights for easy troubleshooting without counting flashes: Dedi- cated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes.

19 3/4” Wide 23 3/4” Deep 76” Tall

*The M7RL will fit in the same footprint and uses the same duct connector as the M1 & M3 funaces. The design of the M7RL allows for direct substitution in place of the M1 & M3 series furnaces.

Part #

Accessories

901083

Automatic Cavity Damper

901985

“VEE” Box Adapters (10”)

902149

“VEE” Box Adapters (12”)

911969

A/C Coil Box

904953

Concentric Vent Termination Kit

914229

Sloped Roof VentilAire IV Kit

Price

All Prices Subject To Change At Any Moment WITHOUT NOTICE!

Document info
Document views227
Page views229
Page last viewedThu Dec 08 21:37:58 UTC 2016
Pages30
Paragraphs2597
Words6701

Comments