X hits on this document

PDF document

Sample Specifications for Rosco Subfloor System – - page 4 / 8

24 views

0 shares

0 downloads

0 comments

4 / 8

  • C.

    Finish Floor:

    • 1.

      Vinyl: Rosco Laboratories: “Dance Floor” vinyl flooring, 1.3 mm thickness, loose laid on subfloor with cloth gaffer’s tape to join adjacent rolls.

    • D.

      Base: Vented cove as specified below.

    • E.

      Total thickness of Subfloor and finish floor: 2 1/8”

      • 2.3

        SEMI-PERMANENT INSTALLATION OF ROSCO SUBFLOOR SYSTEM

SPRUNG FLOOR ASSEMBLY WITH VINYL FINISH FLOOR

  • C.

    Vapor Barrier: Polyethylene sheet as specified below.

  • D.

    Subfloor: Rosco Laboratories Inc. Subfloor System semi-permanently

installed consisting of the following:

  • 1.

    Rosco Subfloor System Panels consisting of:

    • a.

      1” thick closed cell foam pads

    • b.

      ½” Medium Density Fiberboard Sleeper Layer

    • c.

      ½” Medium Density Fiberboard Top Surface Layer

    • d.

      Panels are glued in the factory with wood composite glue and minimum adequate clamping force (1872 psf minimum uniformly applied for at least 30 minutes).

    • e.

      Panels are edge rounted with 1/16” roundovers on all exposed edges.

    • f.

      Panels are joined with extended wavelock tabs and corresponding recesses in the sleeper layer.

    • g.

      All Medium Density Fiberboard to be homogenous domestically sourced hardwood based and domestically manufactured.

    • h.

      All materials to be warehoused within prescribed humidity requirements of the manufacturer.

    • i.

      All panel batches are to be checked against caliper standards for length and width and edge swelling standards.

  • 2.

    The edge of the subfloor is finished on site with Rosco Subfloor System Customizing Panels consisting of:

    • a.

      1” thick closed cell foam pads

    • b.

      ½” Medium Density Fiberboard Sleeper Layer

    • c.

      ½” Medium Density Fiberboard Top Surface.

    • d.

      Customizing Panels are edge rounted with 1/16” roundovers on all exposed edges.

    • e.

      Customizing Panels are joined to Subfloor panels with extended wavelock tabs and corresponding recesses.

Specialty Dance / Performance Floor Assemblies

Section 09646

Document info
Document views24
Page views24
Page last viewedSun Dec 11 08:04:30 UTC 2016
Pages8
Paragraphs292
Words2161

Comments