X hits on this document

43 views

0 shares

0 downloads

0 comments

2 / 14

3.

ASTM C 1002: Specification for Steel Self-Piercing Tapping Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs.

4.

ASTM C 1396 – Standard Specification for Gypsum Board.

5.

ASTM C 1629 – Standard Classification for Abuse-Resistant Nondecorated Interior Gypsum Panel Products and Fiber-Reinforced Cement Panels.

6.

ASTM - D 3273 – Standard Test Method for Resistance to Growth of Mold on the Surface of Interior Coatings in an Environmental Chamber.

7.

ASTM E 119 – Fire Tests of Building Construction and Materials.

C.

American Wood Products Association (AWPA) C27 – Fire Retardant Treatment by Pressure Processes.

D.

Federal Specification QQL-201 F Grade C.

E.

Hollow Metal Manufacturers Association (HMMA) 840 – Installation and Storage of Hollow Metal Doors.

F.

National Council on Radiation Protection and Measurements (NCRP):

1.

NCRP Report No. 145 – Radiation Protection in Dentistry.

2.

NCRP Report No. 147 – Structural Shielding for Medical X-Ray Imaging Facilities.

3.

NCRP Report No. 151 – Structural Shielding Design and Evaluation for Megavoltage X- and Gamma Ray Radiotherapy Facilities.

G.

Steel Door Institute (SDI)-100 – Recommended Specifications for Standard Steel Doors and Frames.

1.4

ADMINISTRATIVE REQUIREMENTS

A.

Pre-Installation Meetings:  Conduct pre-installation meeting to coordinate radiation protection survey and verify project requirements and substrate conditions.

1.5

ACTION SUBMITTALS

A.

Submit under provisions of “Section 01 33 00 - Submittal Procedures.”

B.

Product Data:  Manufacturer's data sheets on each product to be used.

C.

LEED Submittals:

1.

Product Data for Credit MR 4:  For products having recycled content, documentation indicating percentages by weight of postconsumer and preconsumer recycled content.  Include statement indicating cost for each product having recycled content.

2.

Product Certificates for Credit MR 5:  For products and materials required to comply with requirements for regional materials, certificates indicating location of material manufacturer and point of extraction, harvest, or recovery for each raw material.  Include statement indicating distance to Project, cost for each regional material, and fraction by weight that is considered regional.

3.

Product Certificates for Credit MR 5:  For products and materials required to comply with requirements for regionally manufactured [and regionally extracted and manufactured] materials.  Include statement indicating cost for each regionally manufactured material.

a.

Include statement indicating location of manufacturer and distance to Project for each regionally manufactured material.

b.

Include statement indicating location of manufacturer and point of extraction, harvest, or recovery for each raw material used in regionally extracted and manufactured materials.  Indicate distance to Project and fraction by weight of each regionally manufactured material that is regionally extracted.

RADIATION PROTECTION13 49 00 - 2

Document info
Document views43
Page views43
Page last viewedSun Dec 04 02:06:56 UTC 2016
Pages14
Paragraphs708
Words5391

Comments